Buy One Get One 25% Off for all standard crib bedding+ Free Shipping Over $30

Idea With No Sewing Crib Rail Cover

When babies are teething, they will chew on anything they can get in their mouths. Unfortunately, crib rails are the perfect height for a standing baby who wants to sooth aching gums. This easy DIY crib rail cover will protect both your baby and your crib.

HOW TO MAKE THE DIY CRIB RAIL COVER

The DIY  crib rail cover  is easy and inexpensive. It’s made with only a yard or two of fleece and it doesn’t require any sewing or fancy tools. Best of all, it covers the damage made by C1 and keeps C2 from making it worse. There are so many fleece colors you can choose to match your nursery decor. I chose a chocolate brown fleece to blend with my dark crib.

 

WHAT YOU NEED:

Fleece

Measuring tape

Scissors

INSTRUCTIONS:

Wondering how to make  crib rail covers? Just follow these steps. It’s easy and you don’t need to sew.

 

STEP 1: MEASURE THE CRIB.

Use the measuring tape to determine the length of the front and sides of your crib. Next, drape the measuring tape all the way around your rail and add 8 inches. This will determine the width you need for your crib rail cover . In my case, the sides and front of the crib rails are different sizes, so I needed two different widths.

 

Next measure the width of your vertical crib railings and the spaces between them.

 

STEP 2: CUT THE FLEECE.

Measure your fleece and cut to the overall length and width you determined in the previous step.

 

Next lay the fleece on a flat surface and cut four-inch long slits along the length of the fleece as shown in the photo below. Use the width measurement of your vertical crib railings and the spaces between them to determine how far apart your slits should be.

 

Alternately, Jane Marie Photography suggests draping the fleece over the side of the crib and cutting slits in the fabric in the spaces between the vertical railings.

Repeat the 4-inch vertical cuts along the opposite side of the fleece, as shown.

 

 

STEP 3: TIE THE DIY CRIB RAIL COVER ON THE CRIB.

Drape the fleece over the side of your crib. You want it evenly positioned along the top of the crib rail

 

Start at one end and tie the cut strips together in the spaces between the railings. You’ll only do every other one.

Continue until you’ve tied the entire DIY  crib rail cover  to that side of the crib.

 

Once you’ve tied the entire DIY  crib rail cover  on a side, you can tuck the remaining fleece strips up into the crib rail itself or cut them off.

 

Repeat the process on the front and remaining side of the crib to finish the DIY Crib  crib rail cover .

There you have it! The DIY  crib rail cover  is a simple and low cost solution to a common problem for parents. The DIY  crib rail cover  will make your crib look as good as new for your baby.  the DIY  crib rail cover  is machine washable. You can wash yours in cold water on a delicate cycle and then dried it on low heat to help prevent the fleece from piling.

Leave a comment

Name .
.
Message .

Please note, comments must be approved before they are published