I've gone back and forth about putting a crib bumper pads in our baby's crib. I know a lot of parents who swear by them and claim that they keep their baby from bumping its head on the hard wood of the crib or sticking arms and legs between the slats. Experts say that if the crib bumper pads is too thick, babies can get pressed up against it and have difficulty breathing, increasing the risk of SIDS. Bumpers left on too long can end up serving as a hoisting agent for toddlers anxious to climb out of bed.
Ultimately, Nate and I decided it's all about timing. Initially, our baby is going to be in a cradle next to our bed and isn't even going to use the crib for a few months, so we can use a crib bumper pads simply for decorative purposes during that time. Beyond that, we'll play it by ear – but we did make sure to make a crib bumper pads with thin batting so it's very breathable, just in case.
Measure the length and width of your crib (mine was 52 1/2″ long and 26 1/2″ wide). Height doesn't matter because we're going to cut all pieces to 11″ high. This height seems to be about average for a crib bumper pads.
Cut batting in the exact width and length of the crib (I cut 2 pieces of batting to 52 1/2″ x 11″ and 2 pieces of batting to 26 1/2″ x 11″).
For all four sides of the crib bumper pads, pin the batting to the corresponding fabric layers with the fabric layers on bottom. You'll notice that the batting is 1/2″ shorter than the fabric layers. This is intentional to leave a 1/2″ seam on one end, which you will slip-stitch later.
For each of the crib bumper pads' four pieces, sew three sides with 1/4″ seams. Leave open the end where the fabric is 1/2″ longer than the batting.
Fold the 1/2″ seams in opposite directions (one over the batting and one underneath itself) and iron flat.
Turn each piece inside out.
Pin the opposite-colored seams together.
Slip-stitch the opposite-colored seams together.
Cut 16 strips in one of the fabric colors to 1″ x 23″. These will be the ties that attach each crib bumper pads' piece to the crib.
Fold down both ends of each tie 1/4″ and iron flat.
Sew the flattened ends.
Fold the sides of each tie into the center and iron flat.
Fold each tie in half length-wise and iron again.
Sew each tie with the smallest seam your sewing machine will allow.
Stitch ties onto the corners of each of the crib bumper pads' pieces.
Tie each piece onto the crib. Voila! While it's important to be aware of the expert opinions, it's best to use your own judgment about what works best for your family. What works for one child doesn't necessarily work for another, so you should keep an eye on your baby and be aware of when he or she may be too old for crib bumper pads and might start using them to hoist him or herself out of the crib. If nothing else, crib bumper pads complete the look of the nursery during the period when the baby is still sleeping in a cradle or bassinet.
Do you want crib bumper pads?Just click: https://www.biloban.com/collections/crib-bumper-1/products/biloban-crib-bumper-pads-nursery-3d-wave-print-fit-for-standard-crib-52x28